Fusion 360

Origin located at BOTTOM of stock

Tool numbers up to date w/ installed bits

Contour cuts on correct side of cutting line (inside, outside)

Feed per tooth < 0.01 // in general, soft materials such as foam can exceed this threshold

Optimal Load <= Tool Diameter x 0.25 // 2D & 3D adaptive tool paths

Simulation free of errors & warnings

Laguna specific post processor used (output file has .PRG extension)

Post processor uses "DOCUMENT UNITS" setting

Laguna Control

Door to fabrication room closed

At least one other staff member in Proto Studio (in case of emergency)

Everyone has appropriate PPE (glasses, headphones, mask)

Position rods lowered

CNC bed clear except stock

Stock secure to bed via vacuum pressure, double sided tape, tabs or fixture

G-Code verified

All bits zero'd via auto touchoff

X/Y zero point established

Vacuum pump on

Dust collection on

Everyone located at a safe distance from CNC

CNC operator within reach of an e-stop