Maintenance

Check the oil level on the back of the spindle head, top off as needed
On Laguna control console, press the “Lubricant Pump” button
Release the button after a few seconds
After a few seconds, use the remote to manually jog the spindle through the full X,Y,Z range of motion to distribute the oil
Repeat this operation for every 15 hours of use or after the machine has been sitting idle for an extended period of time

Minimum spoil board thickness is 0.5”
Be mindful of the position rods when leveling
- Rods should be in the down position when cutting
- Cutting depth should be at least 1/8” above position rods in stowed position
In Fusion 360
- Create extruded rectangle corresponding to spoil board size
  - Alternatively use pre-made project https://a360.co/4aps348
- Use ‘Flycut Template’
- Make sure the stock thickness in setup is identical to model thickness
  - Model should not be centered within larger stock (e.g. 0.6” model in 1” stock)
- Make sure origin is located at bottom of model
On Laguna Control Screen
- Setup > CNC Positions
- Set ‘Z-Spoil’ to 0.0
Set X,Y zero point on corner of stock
Run program, should remove less than 1/8” of material
After cut finishes, set ‘Z-Spoil’ to the stock thickness specified in Fusion
- VERY IMPORTANT, DO NOT SKIP